KSR Hera - tgt11 - tgt11
Hem » Pedaler » Boost pedal » Produkt

KSR Hera

KSR
3145 :-
Lagerstatus: Leverans från externt lager- mejla oss för lev tid
FRI FRAKT FRI FRAKT PÅ DENNA PRODUKT
SNABB SERVICE
Vi skickar samma dag om ordern är lagd innan kl 12:00 CET

14 DAGAR FULL RETURRÄTT
Byt eller pengarna tillbaka

KSR HERA Transparent Boost with active 3-band EQ

Like the KSR EROS, HERA is not your typical boost. Where the EROS was designed for playing drop-tuned extended range guitar into the muddiest of amps, the HERA is completely different. HERA is designed to push any amp with more typical standard tunings. This pedal is transparent and the low-end is full, yet clear. It will boost clean without overdrive, add a little grit, or add distortion. HERA has a 3-band active EQ for precision sculpting. Use it in front to add volume or grit to a clean or crunch channel. Or, put it in the loop for some unique boosting and EQ response changes.

Similarly, use HERA before or after the CERES / VESTA or other preamp for even more control over its tones, and in order to get the most out of it based on your power amp situation.

Main Features:

  • Transparent Boost / EQ effects pedal
  • Perfect for pushing any amp while using standard tunings
  • Designed to work as clean boost, add a little grit or add distortion and provide additional control over your preamp’s sound
  • Stacked internal gain stages to mimic the behavior of full-size tube amps
  • Active 3-Band EQ – for detailed tone-sculpting
  • Backlit KSR logo status indicator
  • True Bypass Switching
  • Compact, pedalboard-friendly form factor
  • Manufactured in USA
  • Powered by opt. 9V DC PSU (centre -, 2.1 mm, 200 mA max. current draw)

 

This is not “just another TS style boost,” therefore it should not be setup in that way. e.g. don’t crank the Level and cut the Gain. Start with both at noon and go from there. The Feel (tight/fat/thick) and Mode (clean/clip/dirt) switches will lose effectiveness the lower the Gain control is set. Further, the higher Level is cranked the more internal distortion can be generated in the last gain stage, and therefore it will add distortion within the HERA coupled with a higher Gain setting. With a lower Gain setting the last stage will remain unclipped, but a huge signal will slam the front end of any amp. This can be too large a signal to achieve your desired sound. e.g. too much saturation due to lack of headroom in the amp’s first stage. In short, all the controls will interact, and there are countless ways you can run this pedal. Please experiment!

Läs mer



We've selected shipping to

SVERIGE

[Change country below]